Problem after upgrade from 1.0.8 to 1.1.1

[plongstaff]

I copied mantis-1.1.1 to my site (dreamhost), copied the config_inc.php file from 1.0.8 to 1.1.1 and ran admin/install.php. The installation went with no problems. After I logged in, all of the issues came across (seen in My View), but the View Issues page showed nothing, even after I modified the filters.

Well, after some experimenting with debug statements added to the php code and viewing the page source, I ended up doing the following:
1) commented out lines in filter_draw_selection_area() to remove collapsability
2) set the config value dhtml_filters to 0

This allowed me to see that the table for the issues was starting to be built. However, I only saw the first 5 or 6 columns (out of the default set) and none below that. I found that if I used the config editor to set the columns to be displayed to a smaller number, it worked fine.

Our dreamhost account is set to use PHP 5.2.2.

I can run like this. Do you want me to log bugs for you about this?

Phil

[seiji]

Maybe memory_limit in php.ini is too small. check your memory_limit.